Odometer Correction with the Diagprog 3 programmer

Easy and Safe Mileage Correction


E46 330 mileage data stored in 150+ memory locations

E46 330 mileage data stored in 150+ memory locations Odometer Correction with the Diagprog III programmer:
Easy and Safe Digital Mileage Correction

E46 330 mileage data stored in 150+ memory locations

 
Post new topic   Reply to topic    Odometer Correction Forum for Digital Mileage Correction -> Mileage Correction BMW
 
Author Message
victorwu
Junior member


Joined: 27 Jun 2008
Posts: 10

Posted: Fri Jun 27, 2008 7:12 pm    Post subject: E46 330 mileage data stored in 150+ memory locations Reply with quote

Hello Everyone:

I have been reading through this forum and found lot of good stuff on fixing my mileage display correctly that I want to do after my engine swap.

Ride is a 2004 330CI zhp. I have read thus far here that the mileage data is stored in Speedo Cluster, Keys, LCM and EWS. However, while doing some research I found a note stating:

"The newer BMW models from year 2004 onwards have the mileage stored in similar locations as the older models but, each electronic control unit will store the mileage when there is a fault on that system, e.g. the ABS unit picks up a fault, not only will it record the fault details but also the mileage at which the fault was developed. Now that's a 150+ locations where the mileage can be stored."

But so far after monitoring the forum I have not found anyone stating this and wondered if this is even true? Perhaps it is or perhaps not. Any comments?

Finally, another question I had for the experts is that will the "BMW M35080 On-line Programmer" do the job? Its about a $200 part. Also, will I need to take the speedo cluster out or I can go through the diag connection terminal?

If I need other fancy (more so expensive) equipment I would'nt mind just getting it done from someone.

Any thoughts/advise/comments are appreciated.

Thanks.
Back to top
jimdashkirk
Member


Joined: 18 Jun 2008
Posts: 46
Location: bonnie scotland

Posted: Fri Jun 27, 2008 7:51 pm    Post subject: : E46 330 mileage data stored in 150+ memory locations Reply with quote

no mate, no error scan on that model .
cluster has eeprom to program .
Do lkm diag
do ews via your picture, if you aint got one , yet me know i will send it.
easy two wires with arsefixer, or only 1 wire with dp3.


if you need any further advice send a pm. cheers
Back to top
victorwu
Junior member


Joined: 27 Jun 2008
Posts: 10

Posted: Wed Jul 02, 2008 6:34 pm    Post subject: : E46 330 mileage data stored in 150+ memory locations Reply with quote

If this can't be done via the diag port aka obd II port, then why does DIGA-Consult website states that it can be done via simple plug and play?

I have spent past several weeks researching this topic and info. seems to be there but not in detail. For example, an e46 made in year XXXX can be done via diag port but if made in year YYYY can't be done via diag port. But at the same time I have checked various software/hardware combo's such as DIGI and PA Soft which state its a plug and play.

What is the reasoning? Is it because BMW decided to make it more difficult to perform this operation?

And why in the hell these equipment/sw manufacturers claiming P'n'P when its not?
Back to top
Display posts from previous:   
Post new topic   Reply to topic    Odometer Correction Forum for Digital Mileage Correction -> Mileage Correction BMW All times are GMT
Page 1 of 1

Topic Author Forum Replies Posted
No new posts Tacho mileage calculator!!!! factoring General questions 2 Wed Nov 26, 2008 2:59 pm
No new posts 1991 E31 V12 M/T BMW 850 Where is th... Avechuchoaxel Mileage Correction BMW 11 Thu Nov 20, 2008 11:55 pm
No new posts Digital Mileage Correction Services W... REMAP.ME.UK Odometer Services: Addresses and Contacts 0 Sat Nov 15, 2008 8:34 pm
No new posts whats the strangest mileage job you h... gaz Open Discussion 7 Tue Nov 11, 2008 7:45 pm
No new posts Mileage Correction Stilo reprog-auto Mileage Correction Fiat 2 Mon Nov 10, 2008 8:24 pm


 
Jump to:  


Protected by Anti-Spam ACP

Diagprog III Kit

Professional version

€ 8.999,00
7.479,00
in stock
+ 19% VAT (BTW)

Version Mercedes-Benz
3.700,00
in stock
+ 19% VAT (BTW)

Version VAG Modelle: VW / Audi / Seat / Skoda
4.100,00
in stock
+ 19% VAT (BTW)

Version BMW & MINI
3.200,00
in stock
+ 19% VAT (BTW)

includes: Hardware, software, all related cables and detailed instructions on a CD with exactly described programming steps as well as high-resolution illustrations as well as a communication programme for the speedometer.
One-week crash course on request in five languages: German, Spanish, English, Greek, Croatian Transportable laptop with integrated instructions and communication programme for the DP3-speedometer system and a professional soldering and hot-air station with fine soldering iron and an integrated hot-air station.


DP3 prices and support