Odometer-Correction.com

[stephane]

hello
i'have try to program it with 3 points solder
but nothing someone can help me please
the dash was made the 20/03/2000
it's not the same in the manual but i have solder the 3 point
but i can't know the good version
please help me

[Nick]

Hello Stephane,

only if you read the original mileage you can program it.
Maybe it´s a new dash and there is an eeprom???

Regards,
Nick

[momo]

hello
i'm sure it's not an eeprom it's processor hc08
the car it's an 2000
but the manual diga tell solder only three point
but i don't know if it's the same sens 1.2.3 or 1.3.2or 3.2.1etc
please help me
thanks

[macshade]

I have the same problem, doing by can apper's ????? so i didn't program, but by 3 point soldering the diga stays in working in all version except 2000 V3, but in 2000 V3 it says wrong checksum!!! I simply cannot program this. Can you help me?

[michel]

I have absolutely same problems. I have made 3 Punto dasboards year 2000-2001 and all was not able to change. Only with CAN dongle and rear cluster connector, but only km UP!!! I think Diga have little (BIG )) problem on it. Same as Skoda Fabia over OBD.

[macshade]

I tested in two car's same result, it simply doesen't work. i tried by can but i didn't suceed.... when it read's it show's ????? if i program the cluster goes to error.... then i have to program it with year 2000 version 3 it work's but stays in 0 KM. But i need to put correct KM and didn't succedd.