MB sprinter VDO 1999 programing problem !

[Tommy]

Hello, now i got a problem .I programed a MB Sprinter VDO 1999 with Diga Consult + VDO cable MB spint/VDO ... milage was 249782km and after programing 000000km . I connected the black connector in black connector-female on backside of clusterhouse . What should i do now ?
Can i open the cluster to program with clip , maybe i need a dumpfile ?

Its urgent with this auto its going on export tomorrow !
Thankfull for help like always !

Regards Tommy

[micky]

If the cluster reads 000000, the DATA has not been corrupted its the Eeprom that has self set to ZEROs.

Rebuild and drive around 20 miles, then read and write Eeprom direct.
The Eeprom reads and writes in MILES. It will display the miles covered from ZERO not the original distance.


NOTE : Select the version that reads the correct OLD value in miles, remember this will be only the 20 or so miles you have recorded since ZERO.
The one I did had 93S46 and read on Port 1, from previous post I understand 93C46 reads on Port 0.

[Tommy]

The cluster is fabricated 24-02-1999 and the chip is 93s46 .

[Tommy]

thanks for fast answer ! i dont know how or what i did but it worked finally with VDO-cable diagnos .

reg.Tommt