Odometer-Correction.com

[mohsinauto]

I have DIGA-Consult or Tacho universal 2007 and I want to adjust mileage for Toyota Hiace 2006.

How can I do it, can anybody help me

[hcip]

[mohsinauto]

Thank you hcip very much,
I can't find SW13 Cable in my Tacho universal 2007 Kit. Can you show me the picture of this cable SW13 and where to connect the it to cluster?

I attached the pictures of Hiace cluster

Thank you again
mohsinauto@hotmail.com

[hcip]

You can use clip if you have no SW 13 cable
SW13 cable is the wire like in your cable in clip

it has pin configuration 1 8 2 7 3 6 4 5
pin 1 is the wire with stripe

[hcip]

[mohsinauto]

Thank you very much.
Your explanation is very clear and easy to do but my cluster doesn't look like the photo you sent. It is different, There is no big IC near the EEprom and I can't find these contacts.

Thank you very much

[mohsinauto]

Yes , it is the same cluster, After I removed the front white cover, it is the same,

But I get 000000 also after soldring the contacts, and also tryed to put the clip directly on the eeprom 93c56.

[mohsinauto]

Hi,

Yes , it is the same cluster, After I removed the front white cover, it is the same,

But I get 000000 also after soldring the contacts, and also tryed to put the clip directly on the eeprom 93c56.

I didn't unerstand the two red circles and the black circle on the cluster plug?

[hcip]

[mohsinauto]

Hi hcip,
Thank you for your patient with me. You are a wonderful person. I hope we can be friends and offer such good and excellent help always.

I think now I know my mistake. When I pulled the wires out of the clip I get number 1, 2, 3, 4 right, but 5, 6, 7, ,8 wrong. I just made them opposite. like this 8 7 6 5

Now I can’t try again because I gave the cluster back to the customer, but now I think I know my mistake.

Is soldering these contacts the only way to do it? Can’t I do it by clip? Because I tried to do it by putting the clip on the 93c56 chip but I get the same result.

[Clusterslaststand]

It should work with the clip.
Maybe the soldering on the wires of the clip was bad or the legs of the eeprom where not clean.
Use fibreglass pen and pcb cleaner to clean legs next time.

[mohsinauto]

Thank you very much
and I don't have to change the sequence of the wires in the clip? Because I know that Toyota Yaris 2003 I should change the sequence of the wires in the clip.

[hcip]

[Bannybasher]

if you need to remove the laquar use nitromoors . it works a treat. a little bit on a ear bud, leave it to soak for a few minutes.
Rub off with a fibre glass pen . easy.

A point about the yaris with rotated pins:
if your 95 board have a port 4, then use that port
it saves time moving all the pins two to the left.