Odometer-Correction.com

[__snake__]

Hi,

Please i want to see a tutorial how to remove bsi from car,
then where is the eprom located ...etc

All what can be possible about BSI

All the best

[zak]

you must find eprom "95256"

Desolder it. Clip it - and write 0 kilometer/miles.

[__snake__]

Thank you soo much

But you gave me only the picture's where is the Bsi located

i search how to remove it, then how to open it and find the eprom

[zak]

sometimes it is necessary to break the right side of
the BSI.

Then the BSI is produced with a break section intended.

[__snake__]

All is clear now,
This what i was searching for.

Cuz, i had last time a Bsi and it was soo difficult to desolder the pin's !

Thank you soo much man

[__snake__]

Please look here :

http://www.odometer-correction.com/forum/ftopic2236.html

I need the same thing with a 206

Thank you

[zak]

for desoldering eeprom i use ersa digital unit with pincette.

look here:

http://www.ersa.de/en/

desoldering time for an eeprom: 3 seconds

i have no time for hot air tools.

the ersa tool is high quality made in germany.

all kind of soldering tips for the pincette suitable - for all kind of eeproms,
also for plcc !!!

dont waist time with hot air tools!

best choice is i-con 2 - with pincette for desoldering
and with soldering i-tool

[__snake__]

Thank you for all those info,

But i have already ordered a InfraStation,

[Bannybasher]

whats all this about de soldering????
i never have to remove eeprom. had a bit of trouble with a belingo
once , but all read ok in the end.

[Clusterslaststand]

Big Big hammer to crack tiny peanut!

[boyakst]

Hi everybody

Bannybasher, what dod you do if you never remove the eeprom?
I think sometimes it is necessary to disolver te eeprom.

[Bannybasher]

clip osc . clip eeprom to read. you may have a few attemps. sometimes eeprom is covered in laquar you will need to remove this.
with diga is hard to know if you have connected all 8 pins.
using dp3 the box will tell you which pins are out.
i only remove this chips that i have to change i;e m30580 v6
and some fiat puntos.

good luck

[boyakst]

Clip osc I don't understand... lol

BUt here the problem is for a 307 peugeot.
We have to change on the BSI only and then the custer will take the value of the BSI.
But how to change in the BSI without the 912 V2?
Only with the clip?

[Clusterslaststand]

When you say diga consult, do you mean chinese clone or proper diga consult?
I think you should pass on the 307 and start practicing on easy ones first, then you wont end up with mistakes.
Just do some cluster only jobs to start with.
Good luck
TDS

[boyakst]

No! It is not a chinese one,just an announce from an old user.
We don't make it as a job
I buy it with some friends, because we all want to make our cars.
Using our manual we arrived to do my Scenic, the 306 peugeot of a friend.
Now today it is the turn of the 307 Peugeot year 2002 and after Clio year 2007.

I hope thanks to you we can find some help for these cars!