Odometer-Correction.com

[__snake__]

Hi,

Please i want to know which place of the bsi plastic i must cut to see the eprom and desolder it,

cuz i cant remove the card, the iron soldering is too hard to desolder them, so i decided to remove the plastic cover.

Here is a picture please surround for me the place i must cut, thank you

[/list]

[Bannybasher]

you will have to unclip the bsi. i have done lots of bsi
and have never experienced anyone cutting squares out of the plastic;

but its a funny world..

Also if you are using diddy diga you dont need to remove eeprom
from pcb.

good luck.

[__snake__]

it's easy to see the eprom ?

i mean easy to separe the board from the plastic cover ?

Thx

[Bannybasher]

very easy , just be careful you dont snap the clips.
i have seen lots of bsi with the clips snapped, not a huge problem
but looks messy.

[__snake__]

The problem is that i havent a good hot air station, the maximum heat is 200°, so i prefer that i cut the plastic cover

so, please made me a surround on the place where is the eprom located

All the best